| The One Ring http://gbain.powweb.com/ |
|
| Best way to cut thick models in half http://gbain.powweb.com/viewtopic.php?f=30&t=31322 |
Page 1 of 1 |
| Author: | LordoftheBrownRing [ Tue Jul 21, 2015 12:57 am ] |
| Post subject: | Best way to cut thick models in half |
How? First of all I dont want to spend a ton of money on industrial strength machines. I need to do a few things like cut through metal Theodred mounted for a conversion and cut thick models like rangers in half. |
|
| Author: | Oldman Willow [ Tue Jul 21, 2015 4:32 am ] |
| Post subject: | Re: Best way to cut thick models in half |
Jewelers-Adjustable-Assorted-Tension/saw  You will need a vice as well. I like the one UK Freddie made. A pair of vice grips would also work. A table mounted vice would be much better. I was looking for an inexpensive vice as an example I found this one I ordered for myself. http://www.micromark.com/gentle-jaws-3- ... ,7557.html 
|
|
| Author: | jdizzy001 [ Tue Jul 21, 2015 4:38 am ] |
| Post subject: | Re: Best way to cut thick models in half |
A saw. Gale force 9 sells some good saws too. |
|
| Author: | Afastr [ Tue Jul 21, 2015 10:34 am ] |
| Post subject: | Re: Best way to cut thick models in half |
Jewellers saw as noted above, takes a bit of time getting the nack but cuts through metal quicker and cleaner than anything else I've tried. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|